Author: WGT Publish Time: 19-11-2021 Origin: WGT
1. Too much oil is added to the servo reducer:
When the reducer is used, the oil pan will be stirred violently, and the lubricating oil will be dispersed on the whole machine.
2. The structural design of servo reducer is unreasonable.
3. There is no oil return groove in the box, and the lubricating oil accumulates at the shaft seal, end cover, joint surface, etc., and leaks from the gap under the action of differential pressure; The inspection hole cover is too thin, which is easy to deform after tightening the bolts, resulting in uneven bonding surface and oil leakage in the contact gap.
4. During the manufacturing process of servo reducer, the castings were not annealed or aged, and the internal parts were not removed. Inevitably, stress and deformation will lead to clearance and leakage.
5. The structural design of shaft seal is impractical. The early servo reducer mainly used oil groove and felt ring shaft seal structure, and the felt was deformed due to compression during assembly, and the gap between joint surfaces was sealed. If the contact between the journal and the seal is not ideal, the seal will soon fail because the felt compensation is very low. The oil groove has a return hole, but it is easy to block and it is difficult to obtain the return effect.
6. Pressure difference between the inside and outside of the servo reducer: when we use the reducer, the temperature of the servo reducer will continue to rise because of friction heating and the influence of ambient temperature. If you don't use it correctly, the vent will be blocked, so the internal pressure of the machine will gradually rise. The internal temperature of the machine will also increase, and the greater the pressure difference with the outside world, the oil may leak.
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?
Fertilizer Plant Gearbox: Turnaround Season Demand and Sizing Guide
How to judge whether the WP series worm gear reducer is installed in place
How to clean the lubrication system of QJR-D450-20-IX gear reducer
What is the function of the breathable cap of the ZD80-5-2 soft tooth surface gear reducer?
Tissue Machine Yankee Drive Gearbox: Sizing High-Inertia Paper Drives
Wastewater Treatment Gearbox Market 2027: Policy Deadlines and Screw Pump Sizing
Vertical Turbine Pump Gear Drive Selection: Thrust Load, Support and Bearing Life