Author: Site Editor Publish Time: 16-11-2026 Origin: Site
1. Worm gear and worm (core transmission pair)
This is the first and most severely damaged component after an oil leak. The NMRV series worm gear is usually made of tin bronze, and the worm is made of hardened steel. The two are sliding friction transmissions. Once there is a lack of oil, the friction coefficient will rise sharply, resulting in:
Accelerated wear and pitting: When the tooth surface loses the protection of the lubricating oil film, the copper worm gear tooth surface will quickly wear and thin, and even pitting and gluing may occur.
Broken teeth and shaving: In the case of severe oil shortage and dry grinding, excessive thinning of the tooth thickness will cause the transmission gap to become larger, which may eventually lead to broken or shaving of the teeth, causing the reducer to be completely scrapped.
2. Internal bearings (especially worm bearings)
The high-speed operation of bearings is extremely dependent on the lubrication and heat dissipation of lubricating oil. When the oil level is insufficient due to oil leakage:
Burning and locking: Dry friction is formed between the bearing raceway and the rolling elements, which instantly generates high temperatures, causing the bearing cage to deform and the raceway to burn. In severe cases, the bearing may lock and the entire reducer may become stuck.
Decreased accuracy: Early bearing wear will lead to increased axial movement and radial runout, which will not only destroy the transmission accuracy, but will also accelerate the wear of the shaft end oil seal, forming a vicious cycle.
3. Input/output shaft journal
When the lubricating oil is seriously insufficient, the oil film buffer between the shaft and the bearing, and the shaft and the oil seal lip is lost:
Shaft surface strain and wear: Scratches, wear grooves and even rust will appear on the journal surface, resulting in excessive surface roughness. This not only affects the stability of the transmission, but also causes oil leakage to occur again due to uneven shaft surfaces, even if a new oil seal is replaced later.
4. Box and seals (vicious cycle)
High temperature deformation: Dry friction caused by lack of oil will cause the temperature inside the box to rise sharply. Most NMRV reducers are made of aluminum alloy boxes. Sustained high temperatures may cause thermal deformation of the joint surface of the boxes, destroying the original sealing fit and further worsening the oil leakage problem.
Aging of seals: Abnormally high temperatures will accelerate the deterioration of the remaining oil, and cause rubber seals such as oil seals and O-rings to quickly harden and crack, leading to a complete loss of sealing ability.
Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand
Lubrication and maintenance characteristics of B series industrial gearboxes
What are the common misunderstandings in B series gearbox maintenance?
Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor
How does the R series helical gear reducer perform in a strong vibration environment Selection
Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand
Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart
Is there any way to reduce the parallelism error of the reducer?
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?