Author: Site Editor Publish Time: 18-11-2026 Origin: Site
1. Pre-control in the manufacturing process
The box blank has undergone thermal aging + vibration aging to double stress relief to avoid hole position deviation caused by stress release in the later stage.
The bearing hole adopts the "one-time clamping and boring process" to eliminate the cumulative parallelism error caused by secondary flipping and clamping.
Before leaving the factory, the shape and position tolerances of the cabinets are checked one by one, and the JB/T9050.1 standard is strictly followed. Unqualified cabinets will not be included in the assembly process.
2. Precise calibration during assembly stage
The mounting base is finished to a surface roughness Ra3.2 or above, and the flatness error is controlled within 0.05mm/m.
Use the coloring method to check the contact spots of the gear pair. The contact area along the tooth length is ≥60% and the tooth height is ≥45%. Confirm that the parallelism of the shaft system is qualified.
If the contact is deflected, gradually correct the axis parallelism deviation by scraping the bearing bush or fine-tuning the position of the bearing seat.
The dial indicator dual-meter method is used to simultaneously measure the radial and end face runout to ensure that the axis parallelism error of the two axes is ≤0.04mm/1000mm.
Priority is given to the NL type elastic pin coupling, which can automatically compensate for the slight parallelism deviation generated after installation.
3. Precision locking after installation
Gradually tighten the anchor bolts 2 to 3 times in diagonal order. After tightening, the parallelism must be re-measured to avoid "false alignment".
The gaskets should be made of flat stainless steel sheets with a thickness of 0.05~0.5mm. The number of gaskets in a single set should not exceed 3. It is strictly prohibited to use paper, rubber blocks and other easily deformable materials.
After 30 minutes of no-load trial operation, the machine is deemed to be qualified if there is no periodic abnormal noise when monitoring the running sound, and if there is no obvious drift in the parallelism of the shaft system during retesting.
4. High-precision scene optimization
Using a laser aligner for calibration can improve the parallelism measurement accuracy to ±0.01mm, which is suitable for precision transmission conditions.
For chain/belt transmission structures, use a ruler close to the end face of the sprocket/pulley to ensure that the two end faces fit evenly and further control the parallelism deviation.
Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand
Lubrication and maintenance characteristics of B series industrial gearboxes
What are the common misunderstandings in B series gearbox maintenance?
Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor
How does the R series helical gear reducer perform in a strong vibration environment Selection
Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand
Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart
Is there any way to reduce the parallelism error of the reducer?
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?