Author: Site Editor Publish Time: 27-04-2023 Origin: Site
Choice of vibration measurement method
There are two ways to measure the vibration of the gear unit, one is to measure the vibration of the box and the other is to measure the vibration of the shaft.Combining these two measurement methods to obtain the absolute movement of the shaft in the gear unit is also a more effective method.
For gear units supported by rolling bearings, the bearing radial clearance is small, and the relative movement between the bearing and the box is also small, so the box vibration measurement should be used.For gear units supported by ordinary sliding bearings, shaft vibration measurement or box vibration measurement can be used.However, when the frequency is in the range of 0-500Hz, the vibration measurement of the box is insensitive and difficult to measure the tiny vibration, so the shaft vibration measurement should be used.The vibration measurement of the box can obtain a wide frequency range and dynamic characteristics, which can provide the necessary basis for the analysis of the meshing frequency of the gear teeth.
(2) Shaft vibration measurement
The vibration displacement of the shaft shall be measured relative to the housing.A non-contact sensor should be used, and the sensor should be installed as close to the bearing as possible, and fixed at a more rigid part of the box.Vibration shall be measured in three mutually perpendicular directions of the shaft, one of which shall be parallel to the axis.There must be an axial sensor on each shaft.The number and installation position of the measuring points shall be determined through negotiation between the user and the manufacturer.
(3) Vibration measurement of the box
The vibration of the box should be measured at a more rigid part of the box (such as the bearing seat).Measurements should be made in three mutually perpendicular directions, two of which must lie in a plane perpendicular to the axis of rotation of the gear, preferably a horizontal or vertical plane.The number and installation position of sensors shall be determined through consultation between the user and the manufacturer.
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?
Fertilizer Plant Gearbox: Turnaround Season Demand and Sizing Guide
How to judge whether the WP series worm gear reducer is installed in place
How to clean the lubrication system of QJR-D450-20-IX gear reducer
What is the function of the breathable cap of the ZD80-5-2 soft tooth surface gear reducer?
Tissue Machine Yankee Drive Gearbox: Sizing High-Inertia Paper Drives
Wastewater Treatment Gearbox Market 2027: Policy Deadlines and Screw Pump Sizing
Vertical Turbine Pump Gear Drive Selection: Thrust Load, Support and Bearing Life