Author: WGT. Publish Time: 26-11-2021 Origin: WGT
Reducer equipment is one of the indispensable equipment in industrial production.When designing reducers, manufacturers have designed different types of reducers according to the needs of different industries.Today, let us first understand the main requirements of the ZQ reducer during the assembly process:
1. ZQ reducer parts can be installed after cleaning.
2. In assembly order, we can run in reverse order of disassembly.
3. During the assembly process, the surface of rolling or sliding parts should be coated with lubricating oil to form preliminary lubrication conditions.
4. When the cycloidal wheel is installed, please install it according to the position of the prefix when removing the dismounted position.
5. When the output shaft is installed in the base, it is allowed to hit the recess with a red copper rod, but not with a hammer.
6. When the output shaft pin is inserted into the corresponding hole with the cycloid gear, please pay attention to the position of the spacer ring, and fix the position with a pin sleeve to prevent the spacer ring from being crushed.
7. For the oil-resistant rubber sealing ring, we should pay attention to adjust the tension of the spring and apply grease.
8. The bearings of the ZQ reducer can be installed by heating.
9. The sealing paper on the joint surface should be renewed.
10. After assembling the ZQ reducer, the high-speed input shaft can be rotated by hand.It should rotate flexibly without friction interference.
I hope you can understand the assembly point of ZQ reducer equipment.If you encounter any problems in the process of using the equipment, you can consult us.
Gearbox Shaft Seal Selection: Lip, Labyrinth or Cassette for Wet Duty
What methods can be used to avoid failure of the internal gear transmission system of CJY reducer?
What impact will a gear transmission system failure have on the CJY reducer?
Gearbox Market 2027: Retrofit Demand in Southeast Asian Palm Oil Mills
If the gear gap of the reducer is too large or too small, what efficiency problems will it cause?
How to adjust and repair the gear backlash of the reducer if it is too large or too small?
How to carry out dynamic inspection after FAF98-4KW-140-M4 gear reducer is installed
How to deal with abnormal vibration of WPDKS80-60 worm gear reducer under low load
What are the maintenance points for ZDY250-3.55-II hard tooth surface reducer in food plants?
How to perform daily inspection of the sealing system of ZDY315-4.5-I hardened reducer?
What is the clearance standard of P series planetary reducer under different working conditions?
How to choose the P series planetary reducer suitable for your equipment
How to judge the degree of breakage of ZLYJ series reducer gears by listening to the sound
What are the common causes of failure of NGW102-6 planetary reducer bearing components?
What are the repair methods after the NGW81-25 planetary reducer bearing assembly fails?
How to judge whether there is a problem with the internal transmission pair of WP series reducer
What may be the causes of load fluctuations of WP series worm gear reducer?
Gearbox Breather Selection: Dust Caps, Desiccant Dryers and Pressure Balance
Gearbox Price Trends 2027: EU CBAM and the Steel Cost Pass-Through
Gearbox Oil Change Interval: Hours, Oil Tests and Top-Up Rules