Author: WTG. Publish Time: 30-10-2021 Origin: WTG
How to effectively inspect and maintain the reducer.Different lubricants must not be mixed with each other.The positions of the oil level plug, oil drain plug and breather are determined by the installation position.Their relative positions can be determined by referring to the installation position diagram of the reducer.The following describes Shanghai Jinchuan reducer mainly through oil replacement, oil level inspection, oil level plug for reducer, voltage inspection, etc.
1. Oil level plug for reducer
Check whether the oil level is qualified; install the oil level plug.
2. Oil replacement
After cooling, the viscosity of the oil increases, making it difficult to drain the oil.The reducer should change the oil at the working temperature.Cut off the power to prevent electric shock!Wait until the reducer cools down and there is no risk of burning!
3. Precautions
Inject new oil of the same brand; the amount of oil should be consistent with the installation position; check the oil level of the oil level plug; tighten the oil level plug and breathe; the reducer is kept warm during the oil change; drain the oil under the drain plug; open the oil level plug, Breather and drain plug; drain all oil; install oil drain plug.
4. Oil level check
Cut off the power to prevent electric shock!Wait for the reducer to cool down; take out the oil level plug and check whether the oil is full; install the oil level plug.
5. Water inspection
Cut off the power to prevent electric shock!Wait for the reducer to cool; open the drain plug and take an oil sample; check the viscosity index of the oil; if the oil is obviously cloudy, it is recommended to replace it as soon as possible.
Gearbox Shaft Seal Selection: Lip, Labyrinth or Cassette for Wet Duty
What methods can be used to avoid failure of the internal gear transmission system of CJY reducer?
What impact will a gear transmission system failure have on the CJY reducer?
Gearbox Market 2027: Retrofit Demand in Southeast Asian Palm Oil Mills
If the gear gap of the reducer is too large or too small, what efficiency problems will it cause?
How to adjust and repair the gear backlash of the reducer if it is too large or too small?
How to carry out dynamic inspection after FAF98-4KW-140-M4 gear reducer is installed
How to deal with abnormal vibration of WPDKS80-60 worm gear reducer under low load
What are the maintenance points for ZDY250-3.55-II hard tooth surface reducer in food plants?
How to perform daily inspection of the sealing system of ZDY315-4.5-I hardened reducer?
What is the clearance standard of P series planetary reducer under different working conditions?
How to choose the P series planetary reducer suitable for your equipment
How to judge the degree of breakage of ZLYJ series reducer gears by listening to the sound
What are the common causes of failure of NGW102-6 planetary reducer bearing components?
What are the repair methods after the NGW81-25 planetary reducer bearing assembly fails?
How to judge whether there is a problem with the internal transmission pair of WP series reducer
What may be the causes of load fluctuations of WP series worm gear reducer?
Gearbox Breather Selection: Dust Caps, Desiccant Dryers and Pressure Balance
Gearbox Price Trends 2027: EU CBAM and the Steel Cost Pass-Through
Gearbox Oil Change Interval: Hours, Oil Tests and Top-Up Rules