Author: Site Editor Publish Time: 14-04-2023 Origin: Site
Why does the planetary reducer have a broken shaft?The first possible problem with a large broken shaft is the quality of the planetary reducer.Of course, this is what we ordinary people can think of, and the main reason is the reason that occurs during the usual use.For example, what should we pay attention to during the acceleration and deceleration process of using the planetary reducer, and what is the best way.
1. Some applications must strictly abide by this criterion. This is not only to protect the reducer, but more importantly, to prevent the output shaft of the planetary reducer from being twisted.This is mainly because, if there is a problem with the installation of the equipment, the output shaft of the reducer and its load are stuck, and the overload capacity of the driving motor will still increase its output, which may cause the output bearing of the reducer to be damaged. The output shaft of the reducer is twisted off if the force exceeds 2 times its rated output torque.
2. In the process of acceleration and deceleration, if the instantaneous torque multiplied by the output shaft of the planetary reducer exceeds 2 times its rated output torque, and this acceleration and deceleration is too frequent, the reducer will eventually break axis.Considering that this situation occurs rarely, it will not be further introduced here.
3. The wrong Selection leads to insufficient output of the equipped reducer.Some users mistakenly believe that as long as the rated output torque of the selected planetary reducer meets the working requirements, it is enough when Selection, in fact, it is not the case. First, the rated output torque of the equipped motor is multiplied by the reduction ratio to obtain the numerical principle On the one hand, it should be smaller than the rated output torque of the similar reducer provided by the product catalog; on the other hand, the overload capacity of the driving motor and the maximum working torque required in practice should also be considered.In theory, the user needs a large working torque.It must be less than twice the rated output torque of the reducer.
Among them, when using the planetary reducer, we must pay attention to its code of conduct, and at the same time, there are fatal reasons for insufficient output to the wrong Selection.The broken shaft of the reducer is too small, and the broken shaft of the planetary reducer is a common problem.In addition to the broken shaft of the reducer caused by poor assembly concentricity at the output end of the reducer.
Fertilizer Plant Gearbox: Turnaround Season Demand and Sizing Guide
How to judge whether the WP series worm gear reducer is installed in place
How to clean the lubrication system of QJR-D450-20-IX gear reducer
What is the function of the breathable cap of the ZD80-5-2 soft tooth surface gear reducer?
Tissue Machine Yankee Drive Gearbox: Sizing High-Inertia Paper Drives
Wastewater Treatment Gearbox Market 2027: Policy Deadlines and Screw Pump Sizing
Vertical Turbine Pump Gear Drive Selection: Thrust Load, Support and Bearing Life
Gearbox Housing Casting Lead Time: Pour Weight, Pattern Slots, 2027 Windows
Gearbox Shaft Seal Selection: Lip, Labyrinth or Cassette for Wet Duty
What methods can be used to avoid failure of the internal gear transmission system of CJY reducer?
What impact will a gear transmission system failure have on the CJY reducer?
Gearbox Market 2027: Retrofit Demand in Southeast Asian Palm Oil Mills
If the gear gap of the reducer is too large or too small, what efficiency problems will it cause?
How to adjust and repair the gear backlash of the reducer if it is too large or too small?
How to carry out dynamic inspection after FAF98-4KW-140-M4 gear reducer is installed
How to deal with abnormal vibration of WPDKS80-60 worm gear reducer under low load
What are the maintenance points for ZDY250-3.55-II hard tooth surface reducer in food plants?
How to perform daily inspection of the sealing system of ZDY315-4.5-I hardened reducer?