Author: WTG Publish Time: 10-10-2021 Origin: WTG
1. The worm is a toroidal worm, the number of teeth meshed with the worm gear increases at the same time, the axial tooth profile of the worm is arc distributed, and the number of simultaneous contact teeth: 3-7 teeth.
2. The machining process is completely consistent with the forming process, which can reliably ensure the manufacturing accuracy and the theoretical state of meshing. The tooth surface of the worm is formed by accurate grinding after hardening treatment. The tooth surface hardness and surface roughness grade can be improved to achieve high tooth profile accuracy. The worm tooth surface is precisely ground after hardening treatment. The tooth surface hardness: HRC ≥ 50, roughness Ra ≤ 0.8.
3. The tooth surface contact area is large, and there is instantaneous double line contact. The total length of the contact line is lengthened, and the tooth surface contact area is greater than 70%. There are two contact lines on the worm gear tooth surface at the same time from both ends to the middle along the tooth width direction, and the included angle between the contact line and the relative speed direction is close to 90 degrees.
4. The tooth surface lubrication angle is large, and the dynamic pressure oil is easy to form in meshing. The tooth surface lubrication angle is large, and the formation and retention of dynamic pressure oil film are good.
5. Planar double enveloping hourglass worm drive is an advanced heavy-duty transmission device. It has excellent characteristics such as large bearing capacity, high transmission efficiency and long service life. It is a good choice to replace other worm drives.
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?
Fertilizer Plant Gearbox: Turnaround Season Demand and Sizing Guide
How to judge whether the WP series worm gear reducer is installed in place
How to clean the lubrication system of QJR-D450-20-IX gear reducer
What is the function of the breathable cap of the ZD80-5-2 soft tooth surface gear reducer?
Tissue Machine Yankee Drive Gearbox: Sizing High-Inertia Paper Drives
Wastewater Treatment Gearbox Market 2027: Policy Deadlines and Screw Pump Sizing
Vertical Turbine Pump Gear Drive Selection: Thrust Load, Support and Bearing Life
Gearbox Housing Casting Lead Time: Pour Weight, Pattern Slots, 2027 Windows
Gearbox Shaft Seal Selection: Lip, Labyrinth or Cassette for Wet Duty