Author: WGT. Publish Time: 31-10-2021 Origin: WGT
One of the reasons for purchasing the oil leaker of the gear reducer is to choose the wrong choice, resulting in a conflict between the installation method and the position of the oil hole, resulting in oil leakage from the oil hole.The correct mounting method should be provided during model selection, otherwise this result will occur.The following small series will explain this issue in detail.
When the reducer is working, the gears run at high speed and generate heat during the contact process through friction.If the machine does not provide an oil hole, the box is sealed.According to the principle of thermal expansion and cold contraction, the temperature increases and the pressure in the box increases.Not only the temperature cannot be dispersed, but also the oil seal will be affected, resulting in oil leakage of the reducer.
According to the above reasons, the oil hole needs to be opened before the reducer is used for ventilation and heat dissipation.The opening position of the oil hole changes with the position of the reducer.If the output shaft is mounted upwards, it should open close to the handle shaft.For example, if it is installed horizontally, the oil hole is on the top of the box.Therefore, ask about the correct installation method for model selection before purchasing.
If the gear reducer has been purchased, but the installation method has not been selected, it will not be replaced after the oil hole is opened.The gear is sealed and cannot be drilled out again as debris will enter the box and cause damage to the gear.If this installation method is wrong, if the machine does not work for a long time, the oil hole can lock the bolts that work about 8 hours a day.This method cannot be used if the working hours are too long.The lubricant in the tank is calculated as 8 hours per day.Under normal circumstances, it can be used for 5~8 years without replacement.
Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand
Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart
Is there any way to reduce the parallelism error of the reducer?
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?
Fertilizer Plant Gearbox: Turnaround Season Demand and Sizing Guide
How to judge whether the WP series worm gear reducer is installed in place
How to clean the lubrication system of QJR-D450-20-IX gear reducer
What is the function of the breathable cap of the ZD80-5-2 soft tooth surface gear reducer?