Author: Site Editor Publish Time: 05-01-2023 Origin: Site
1. Installation
1. Cylindrical gear reducers should generally be installed on a horizontal surface with an inclination not greater than 10°.If the slope is greater than 10° due to special needs, please contact our company to discuss related matters before use.
2. When the input shaft and output shaft are connected with the power and supporting machinery, if a coupling is used for connection, the shafts should be strictly centered without misalignment, and the V-belt and chain should not be too tight or loose.
3. The installation foundation should be firm and reliable, without vibration and looseness.Select fixing screws in strict accordance with relevant standards and regulations.4. From time to time, check whether the installation screws are tightened and fixed firmly.Gaskets use spring washers as much as possible.
2. Lubrication
1. The gear reducer is generally lubricated by an oil pool.Before use, be sure to add medium and extreme pressure gear oil N220 or N320 to the specified position (20-30mm above the lowest gear) and replenish it regularly.
2. After 50 hours of initial use, the engine oil should be replaced immediately to clean the oil stains inside the machine.Thereafter, it should be completely replaced every three months.
3. Please replace the oil seal as soon as possible.
f1 gearbox, use reducer, automatic transmission specialist near me, bevel gearbox, 90 degree gearbox,
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?
Fertilizer Plant Gearbox: Turnaround Season Demand and Sizing Guide
How to judge whether the WP series worm gear reducer is installed in place
How to clean the lubrication system of QJR-D450-20-IX gear reducer
What is the function of the breathable cap of the ZD80-5-2 soft tooth surface gear reducer?
Tissue Machine Yankee Drive Gearbox: Sizing High-Inertia Paper Drives
Wastewater Treatment Gearbox Market 2027: Policy Deadlines and Screw Pump Sizing
Vertical Turbine Pump Gear Drive Selection: Thrust Load, Support and Bearing Life