Author: WeiGao Transmission Publish Time: 31-08-2021 Origin: WeiGao Transmission
After we have used the reducer for a period of time, we will find that its work efficiency has been reduced. The reason is that the equipment has produced a certain amount of dirt after a long time of use, not only on the appearance, but also on the internal parts. No exception, dirt is attached to the parts, causing the parts to slow down. Because the internal parts are inseparable from the equipment, the efficiency of the entire equipment is correspondingly slowed down. At this time, we have to carry out reasonable cleaning of its equipment parts, so how do we do it?
1. Unload the upper housing of the reducer.
If the equipment has a half coupling, remove the half coupling first. Remove the fixing bolts, screw the nuts onto the bolts for safekeeping, and check the upper shell for defects and cracks. Make the assembly mark and remove the bearing end cover. First check whether there are any missing bolts and other abnormal conditions. After confirming that they are correct, lift the upper shell with jack screws, hoist it and place it on the prepared backing plate. Use feeler gauge or pressure lead wire method to measure the clearance of each bearing. Several points should be measured for each set of bearings and record. Drain the lubricating oil in the reducer and store it in a special oil drum.
2. Out of the drive shaft and driven shaft assembly.
Make a mark on the gear mesh. After being lifted, the gear assemblies are placed on a dry wooden board, arranged neatly and securely to prevent bumps, and disassemble the bearings and gears of each shaft.
3. Use kerosene to clean the bearings, casings and gears to prepare for subsequent inspections.
Many people disagree when they find that there is dirt on the internal parts of the reducer, and feel that it will not affect the equipment much, but it just reduces the working efficiency of the equipment. In fact, it is not. When the dirt accumulates, it will become a malfunction problem. , Seriously affecting the operation of the equipment, and even slowly damaging the equipment. Therefore, the equipment and parts must be cleaned regularly, not just the surface of the equipment.
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?
Fertilizer Plant Gearbox: Turnaround Season Demand and Sizing Guide
How to judge whether the WP series worm gear reducer is installed in place
How to clean the lubrication system of QJR-D450-20-IX gear reducer
What is the function of the breathable cap of the ZD80-5-2 soft tooth surface gear reducer?
Tissue Machine Yankee Drive Gearbox: Sizing High-Inertia Paper Drives
Wastewater Treatment Gearbox Market 2027: Policy Deadlines and Screw Pump Sizing
Vertical Turbine Pump Gear Drive Selection: Thrust Load, Support and Bearing Life
Gearbox Housing Casting Lead Time: Pour Weight, Pattern Slots, 2027 Windows
Gearbox Shaft Seal Selection: Lip, Labyrinth or Cassette for Wet Duty
What methods can be used to avoid failure of the internal gear transmission system of CJY reducer?
What impact will a gear transmission system failure have on the CJY reducer?
Gearbox Market 2027: Retrofit Demand in Southeast Asian Palm Oil Mills