Author: Site Editor Publish Time: 21-09-2016 Origin: Site
Weigao mixer reducer reducer special reducer for cement mixing is a reducer with spiral bevel gear + planetary gear structure, with:
1. The spline structure is used to drive the torque between the parts;
2. The planetary gear carrier adopts a floating design to ensure that each gear bears the same load;
3. Both the box body and the connecting body are made of black cast iron, which has the advantages of high efficiency, small backlash, large torque, impact resistance, etc., and can meet the use of 1.5 cubic to 4 cubic mixers;
Use and maintenance:
1. Before the reducer is officially used, the reducer must be turned flexibly by hand without getting stuck, and then run for no less than 2 hours without load.The operation should be stable, without shock, vibration, noise or oil leakage, etc., and the fault should be eliminated in time.
2 After the reducer has been running for 300 to 600 hours, the lubricating oil should be replaced.After that, it will be updated every 1500-5000 hours of operation, which mainly depends on the working environment, but the longest replacement time should not exceed 18 months.When changing the oil, the electromagnetic oil plug should be cleaned at the same time.
3. During operation, if the oil temperature rises suddenly and there is an abnormal sound, please stop checking immediately.After correcting the fault, it can be put into operation again.
cement screw reducer factory screw conveyor reducer
1. The reducer is usually used for transmission equipment with low speed and high torque.An electric motor, internal combustion engine or other high-speed operating power is used to engage a large gear on the output shaft through a gear with a small number of teeth on the input shaft of the reducer.
2. Ordinary reducers will also have several pairs of gears with the same principle to achieve the required reduction.The gear ratio is the ratio of the number of teeth of the large gear to the small gear.
3. The reducer is a power transmission mechanism that uses a gear reducer to reduce the number of revolutions of the motor to the required number of revolutions and obtain greater torque.




Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?
Fertilizer Plant Gearbox: Turnaround Season Demand and Sizing Guide
How to judge whether the WP series worm gear reducer is installed in place
How to clean the lubrication system of QJR-D450-20-IX gear reducer
What is the function of the breathable cap of the ZD80-5-2 soft tooth surface gear reducer?
Tissue Machine Yankee Drive Gearbox: Sizing High-Inertia Paper Drives
Wastewater Treatment Gearbox Market 2027: Policy Deadlines and Screw Pump Sizing
Vertical Turbine Pump Gear Drive Selection: Thrust Load, Support and Bearing Life