Author: WGT. Publish Time: 27-11-2021 Origin: WGT
The reduction motor refers to the combination of the reducer and the motor.The combination may also be referred to as a gear motor or geared motor.Basically, integrated assembly by a professional reducer manufacturer, offered in a complete set-up with motor.If there is smoke from the planetary reducer, you think the smoke problem is caused by the motor overheating caused by the high temperature of the machine for the first time.Of course, there is more than one factor that contributes to motor fumes.There are several other causes of planetary gear reducer smoke:
1. Reduce the motor voltage is too high or wiring error
If the voltage to the reduction motor is too high, it will cause smoke.At this time, it is necessary to reduce the voltage appropriately, and then check whether there is a problem with the wiring.If found, the wiring must be corrected immediately.
2. Motor overload operation
During the operation of the geared motor, the reducer is overheated and can even burn the geared motor.This phenomenon is usually the most common.Usually there are two reasons.One is the overload operation of the geared motor.In this case, the user should check the rated power supply and the load of the geared motor, and adjust the speed to a combined gear,
The second is the lack of lubricating oil, just fill the lubricating oil on time.
3. Frequent forward and reverse rotation of the motor or excessive starting time
Properly reduce the forward and reverse operation of the geared motor or frequent start-up time, or use other types of motors to reduce damage to the motor.
4. Poor ventilation or motor exposure
Check if the motor's fan is damaged or loose.Pay attention to whether there are objects that affect ventilation, and remove them in time to prevent smoke caused by temperature rise.
As shown in Figure 5, the motor voltage is too low, the driving machine is blocked or poorly lubricated
If the voltage is too low and the power cord is too thin, these factors can cause smoke problems.Replacing the power cord can increase the voltage.If there is an overload, the load needs to be reduced.You can also use some cooling equipment to lower the temperature and lower the calorific value.
Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor
How does the R series helical gear reducer perform in a strong vibration environment Selection
Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand
Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart
Is there any way to reduce the parallelism error of the reducer?
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?
Fertilizer Plant Gearbox: Turnaround Season Demand and Sizing Guide