Author: WGT Publish Time: 31-10-2021 Origin: WGT
One of the reasons for the oil leakage of the purchased gear reducer is the wrong type selection, resulting in the conflict between the installation method and the position of the oil hole, resulting in oil leakage from the oil hole. The correct installation method shall be provided during model selection, otherwise such a result will occur. The following small series will explain this problem in detail.
When the reducer is working, the gears are running at a high speed and heat is generated by friction in the process of mutual engagement. If the machine is not provided with oil holes, the box is in a sealed state. According to the principle of thermal expansion and cold contraction, the temperature increases and the pressure in the box increases. Not only the temperature cannot be dispersed, but also the oil seal will be affected, resulting in oil leakage of the reducer.
According to the above reasons, oil holes need to be opened before the reducer is used for ventilation and heat dissipation. The opening position of the oil hole will change with the change of the reducer position. If the output shaft is installed upward, it shall be opened close to the treatment shaft. For example, if it is installed horizontally, the oil hole is located at the top of the box. Therefore, ask the correct installation method before purchase for model selection.
If the gear reducer has been purchased but the installation method is not selected, it will not be replaced after the oil hole has been opened. The gear is sealed and cannot be drilled again, because debris will enter the box and cause harm to the gear. If this installation method is wrong, if the working time of the machine is not long, the oil hole can be locked with bolts working for about 8 hours a day. If the working time is too long, this method cannot be used. The lubricating oil in the tank is calculated as 8 hours per day. Under normal circumstances, it can be used for 5 ~ 8 years without replacement.
Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand
Lubrication and maintenance characteristics of B series industrial gearboxes
What are the common misunderstandings in B series gearbox maintenance?
Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor
How does the R series helical gear reducer perform in a strong vibration environment Selection
Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand
Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart
Is there any way to reduce the parallelism error of the reducer?
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?