The worm gear reducer needs to be run-in when it is used, and there will naturally be some problems in the run-in, which are roughly as follows. 1. The worm gear reducer wears quickly Due to the processing and preparation of the components and control elements of the new reducer unit, the cooperation area is relatively small, and the torque is relatively large.During the operation of the worm gear reducer, there is a problem with the outer material of the components.Metal steps formed by friction are always used as friction material, and then friction damage may occur on the outside of some parts. 2. Occurrence of infiltration If the parts of the worm gear reducer are loose and vibrate, the reducer will also be heated and restricted.Leakage may occur at the connection between the outer sealing surface of the worm gear reducer and the pipe.Some built-in components are missing and not easy to find during device debugging.During operation, for impact, missing conditions will be exposed.Therefore, it is normal for the worm gear reducer to have extravasation during the running-in process. 3. Abnormal lubrication When the worm gear reducer is lubricated, it may cause equipment problems due to the relatively small operating space of the components.It is not easy to form a symmetrical oil film on the outside to avoid friction damage. The smoothness of the worm gear reducer causes severe friction on the front of the component, which can cause external damage and problems.
