1. Generally, cylindrical gear reducer shall be installed on the horizontal plane with a gradient of no more than 10 °. If the gradient is greater than 10 ° due to special needs, please contact our company before use to discuss relevant matters.
2. When the input shaft and output shaft are connected with the power and supporting machinery, if the coupling is used for connection, the shaft shall be strictly aligned with the shaft without misalignment, and the V-belt and chain shall not be too tight or loose.
3. The installation foundation shall be firm and reliable without vibration and looseness. The fixing screws shall be selected in strict accordance with relevant standards and regulations. 4. The installation screws shall be checked irregularly to see whether they are tightened and fixed firmly. Spring washers shall be used as the gaskets as far as possible.
2、 Lubrication
1. The gear reducer is generally lubricated by oil pool. Before use, it is important to add medium and extreme pressure gear oil N220 or N320 to the specified position (20-30mm above the lowest gear) and supplement regularly.
2. After 50 hours of initial use, the oil shall be replaced immediately, and the oil stain inside the machine body shall be cleaned. After that, it shall be completely replaced every three months.
3. Please replace the oil seal as soon as possible.
f1 gearbox,use reducer,automatic gearbox specialist near me,bevel gearbox,90 degree gearbox,
