How to lubricate the gear reducer. The lubrication of the reducer is also a very important link for the maintenance of the reducer. Open and semi open gear reducer drives, or closed gear drives with low speed, are usually lubricated periodically by people, and the lubricant used is lubricating oil or grease. The lubrication of the reducer also has its own conditions, and the lubrication conditions for different reducers are also different. Let's take a look at how Shanghai Jinchuan reducer lubricates the gear reducer.
When the circumferential speed of the gear of the reducer is greater than 12m / s, oil injection lubrication shall be adopted, that is, the oil shall be supplied by the oil pump or the central oil supply station at a ~ fixed pressure, and the lubricating oil shall be sprayed onto the meshing table of the gear teeth through the nozzle. When v ≤ 25m / s, the nozzle can be located at the meshing edge or whistle out edge of the gear teeth; When v > 25m / s, the nozzle shall be located on the side of the gear teeth, so as to timely cool the newly meshed gear teeth with lubricating oil and lubricate the gear teeth at the same time.
The lubrication method of general closed gear reducer transmission is determined according to the circumferential speed of the gear. When the circumferential speed V of the gear is less than 12m / s, the teeth of the large gear are often immersed in the oil ground for oil immersion lubrication. In this way, when the gear is driving, the lubricating oil is brought to the meshing tooth surface, and the oil is also thrown onto the box wall to dissipate heat. The depth of the gear immersed in the oil depends on the circumferential speed of the gear. For cylindrical gears, it is usually not more than one tooth height, but generally it shall not be less than 10mm; Bevel gears shall be immersed in the full tooth width, at least half of the tooth width. In multi-stage gear transmission, oil can be brought to the tooth surface of the gear not immersed in the oil ground by a belt tanker
The amount of oil in the oil pool depends on the power transmitted by the gear. For single-stage transmission, the oil demand is about 0.35 ~ 0.7lo for each transmission of IKW power. For multi-stage transmission, the oil demand is multiplied by stages.
Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand
Lubrication and maintenance characteristics of B series industrial gearboxes
What are the common misunderstandings in B series gearbox maintenance?
Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor
How does the R series helical gear reducer perform in a strong vibration environment Selection
Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand
Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart
Is there any way to reduce the parallelism error of the reducer?
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?