Author: Site Editor Publish Time: 06-03-2024 Origin: Site
1. Remove the protective covers of each component of the hard-tooth surface reducer, remove the motor and brake lines, and mark the disassembly line for reference during future reassembly.
2. Remove the high-speed coupling pin of the hard-tooth surface reducer, loosen the low-speed gear coupling, and move the two half couplings away from both sides.Before disassembling the high- and low-speed shaft couplings of the reducer, a flat shovel or template punch must be used to mark the relative bearings as a basis for reassembling the relative orientation of the couplings.
3. Remove the motor anchor bolts and lift the motor.When the motor's anchors are removed, record the thickness and orientation of the original base gasket as a basis for alignment.Loosen the brake anchor bolts, remove the brake adjustment screw, bump the brake and remove the brake.
4. Remove the check valve of the reducer and place it in the specified position to prevent collision.
5. Make relative orientation marks on the upper and lower joint surfaces of the reducer, remove the fastening bolts on the joint surfaces of the upper and lower covers of the reducer, replace the damaged bolts, and remove the positioning pins.Check the bolts for damage or cracks and tighten the nuts onto the screws for safekeeping.
6. Mark the installation mark of each bearing end cover, remove the fastening bolts of the bearing end cover, remove the bearing end cover, measure the thickness and quantity of the asbestos gasket of the bearing end cover with an outer diameter micrometer, and make original records.Start checking the bearing end cover. There is no wear or crack on the straight end face.
Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand
Lubrication and maintenance characteristics of B series industrial gearboxes
What are the common misunderstandings in B series gearbox maintenance?
Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor
How does the R series helical gear reducer perform in a strong vibration environment Selection
Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand
Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart
Is there any way to reduce the parallelism error of the reducer?
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?