Author: Weigao Transmission Publish Time: 24-09-2021 Origin: 威高传动
Sometimes the shaft of the reducer may be broken.Why does the output shaft of the reducer drive motor break?In order to solve this problem, the cross-section of the output shaft of the drive motor unit of the reducer was checked, and it can be seen that the cross-section of the output shaft is the same as that of the reducer.
This can simply explain that the main factor that causes the drive motor of the reducer to break the shaft is the difference in concentricity between the motor and the reducer device during operation.
If the concentricity loss deviation is large, the radial force will increase the shaft temperature difference transmitted by the motor and damage the metal structure.After all, the radial force will exceed the radial force that the output shaft of the motor can bear, and will eventually damage the output shaft of the drive motor.
When the concentricity of the motor device and the reducer device is perfect, the energy received by the motor drive is the ability to roll, and the lubricity is better during operation.But in the case of non-concentricity, the output shaft should bear the radial force from the input end of the reducer.The long-term effect of this radial force will force the output shaft of the motor to bend, and the bending direction will constantly change as the output shaft rolls.Once the output shaft rolls, the direction of the lateral force changes.
In short, if the motor device is concentric with the input position of the reducer, that is, the reducer and the motor run closely and are in close contact. If the device is not concentric, there will be a gap between the contact surfaces.between them.
The larger the concentricity fault, the shorter the time for the drive motor output shaft to break.When the output shaft of the driving motor is broken, the input end of the reducer will also bear the radial force from the motor.Assuming that the radial force exceeds the maximum radial load they jointly bear, its action will also cause the input end of the reducer to deform or even crack.Therefore, ensuring concentricity is the main way to prevent broken shafts.
The above is the explanation of the reasons for the non-concentricity of the reducer and the high probability of broken shaft, and the related solutions.
Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand
Lubrication and maintenance characteristics of B series industrial gearboxes
What are the common misunderstandings in B series gearbox maintenance?
Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor
How does the R series helical gear reducer perform in a strong vibration environment Selection
Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand
Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart
Is there any way to reduce the parallelism error of the reducer?
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?