Author: Vigo Spread Publish Time: 22-10-2021 Origin: 威戈传播
The terms of the reducer industry are very important and very useful to buy a reducer.Let's take a look at the editor.I hope this study of these terms can help you.
Reduction ratio:
The output speed is higher than the input speed (the inner ring gear is fixed, the sun gear is active)
series:
Regarding the number of planetary gear sleeves, because one set of planetary gears cannot meet the requirements of a large transmission ratio, two or three sets are required to meet the requirements of a large transmission ratio.Due to the increase in the number of planetary gears, the length of the two-stage or three-stage reducer will increase and the efficiency will decrease.
Rated input speed:
When the driving speed and ambient temperature of the reducer are high, please reduce the input speed, which will help to increase the service life of the reducer.
output speed:
Calculate the output speed from the input speed N1 and the transmission ratio according to the following formula.
n2 = n1 / i
Transmission efficiency:
The efficiency on the sample refers to the transmission efficiency of the reducer under full load.
Rated output torque:
It refers to the torque (without wear) of the reducer under load for a long time (continuous working system).Conditions should be met for load safety with a safety factor of FS = 1; rated output shafts comply with gear and bearing standards.
Acceleration torque T2B:
It refers to the * * maximum torque that will be loaded into the output for a short period of time with a duty cycle of less than 1000 cycles per hour.When the duty cycle exceeds 1000 times per hour, the impact factor needs to be considered.T2B is the * * * maximum value in the chosen regular work system.The acceleration torque in actual use must be less than the acceleration torque, otherwise the service life of the reducer will be shortened.
Starting torque T10:
Refers to the torque of the load on the reducer to overcome the friction in the reducer;
***High Torque T2MAX:
It refers to the output torque, which the reducer can bear under static conditions or frequent starting conditions, usually refers to peak load or initial load.
Actual required torque tr2:
The required torque depends on the actual working conditions of the application, and the rated torque of the proposed reducer must be greater than this torque.
Calculated torque TC2
When selecting a reducer, the actual required torque TR2 and service factor FS can be used.TC2 = TR2 *FS≤TN is obtained according to the following formula
Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand
Lubrication and maintenance characteristics of B series industrial gearboxes
What are the common misunderstandings in B series gearbox maintenance?
Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor
How does the R series helical gear reducer perform in a strong vibration environment Selection
Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand
Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart
Is there any way to reduce the parallelism error of the reducer?
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?