1. Pressure difference inside and outside the reducer: during the operation of the reducer, the friction and heating of the moving pair and the influence of the ambient temperature increase the temperature of the reducer. If there is no vent or the vent is blocked, the pressure in the reducer will gradually increase. The higher the temperature in the reducer, the greater the pressure difference with the outside, and the lubricating oil will leak out from the gap under the action of the pressure difference.
2. Unreasonable reducer structure design
1) The inspection hole cover plate is too thin, which is easy to deform after tightening the bolts, resulting in uneven joint surface and oil leakage from the contact gap;
2) In the manufacturing process of reducer, the casting is not annealed or aged, and the internal stress is not eliminated, so it is bound to deform and produce gap, resulting in leakage;
3) There is no oil return groove on the box, and the lubricating oil accumulates at the shaft seal, end cover, joint surface, etc., and leaks outward from the gap under the action of differential pressure;
4) The structural design of shaft seal is unreasonable. The early reducers mostly used the oil groove and felt ring shaft seal structure. During assembly, the felt was compressed and deformed, and the gap on the joint surface was sealed. If the contact between the journal and the seal is not ideal, the seal will fail in a short time due to the poor compensation performance of the felt. Although there is an oil return hole on the oil ditch, it is easy to be blocked and the oil return function is difficult to play.
3. Excessive oil filling: during the operation of the reducer, the oil pool is stirred severely, and the lubricating oil splashes everywhere in the reducer. If the oil filling is excessive, a large amount of lubricating oil will accumulate in the shaft seal, joint surface, etc., resulting in leakage.
4. Improper maintenance process: during equipment maintenance, oil leakage will also be caused due to incomplete removal of dirt on the joint surface, improper selection of sealant, reverse installation of seals, untimely replacement of seals, etc.
Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand
Lubrication and maintenance characteristics of B series industrial gearboxes
What are the common misunderstandings in B series gearbox maintenance?
Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor
How does the R series helical gear reducer perform in a strong vibration environment Selection
Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand
Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart
Is there any way to reduce the parallelism error of the reducer?
Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing
Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake
What specific damage will reversal with load cause to the BWY27-59-4KW cycloidal pinwheel reducer?
How to avoid XLED32-841-0.37KW cycloidal pinwheel reducer with load reversal
Desalination Plant Gearbox Market 2027: SWRO Pump Drive Demand
What are the common problems with NGW42-25 planetary reducer base welding?
What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Slewing Drive Solar Tracker Selection: Wind Load and Holding Torque
Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?