Cycloid reducerIf there is an abnormal sound, check whether it is a fault: that is to listen carefully to the sound from the reducer, whether it is regular or not, this is the key; if it is regular, then this is normal, if the sound is out of scale, it must be a fault.The working sound of the reducer is irregular: then it must be a fault. Generally, in this case, the problem may appear in the motor part and the reducer part. Of course, most of the problems are caused by the reducer.
We need to check whether the curved plate is worn and whether the eccentric body bearing is damaged. If there is no problem with the above two, then check whether the bearings of the input and output parts are damaged.The lubricating oil often used by the cycloid reducer: at normal temperature and low speed operation: generally 40#-50# industrial lubricating oil, which is sufficient; if the speed is high and the working state is under high pressure, it is recommended to use 70#- 90# gear oil; if the reducer often works in a high and low temperature environment, then choose a better lubricating oil.But in general, 80# gear oil is enough to use.
Therefore, it is determined according to the workload and working environment of the reducer. Its function is to improve the performance of the reducer and prolong the service life of the cycloid reducer.When to change the lubricating oil of the cycloid reducer: It is recommended to change the lubricating oil immediately after the new cycloidal pin wheel has been working for 200 hours.The time to replace the lubricating oil in the future shall be determined according to the daily workload of the reducer.The lubricating oil can be replaced every 3 months when it is overloaded every day; the lubricating oil can be replaced every half a year for the reducer that works about 10 hours a day.
