In addition to paying attention to the problems of the product itself, it is also necessary to understand the matters needing attention when using the cycloid reducer, so as to avoid some faults caused by improper operation in the process of use. For the replacement of lubricating oil, the user shall determine the amount of lubricating oil to be injected according to the size of the reducer type. There are specific provisions, and the specific operation shall comply with the operation instruction of the reducer. If the reducer is put into operation in an environment with harsh environment, high temperature and large dust, please check and replace the lubricating oil every 12 months. When using the reducer, replace the blockage on the top of the reducer with the exhaust plug. The purpose of replacing the exhaust plug is to ensure that the reducer will remove the gas generated in the reducer during operation. Otherwise, in the case of long-term operation of the reducer, the gas in the reducer will adhere to it, and the longer the operation time is, the gas will be added, and then the temperature will rise, resulting in the expansion and damage of the reducer oil seal, resulting in oil leakage of the reducer. Because the output shaft structure of the reducer cannot accept axial hammer, the screw can be screwed into the shaft end screw hole to press into the joint.
