To determine whether the worm gear of the WPWA155-50-B reducer is aligned with the teeth (that is, whether the meshing state is normal), the following comprehensive inspection methods are required:
1. Appearance and contact mark inspection
Red red powder coloring method
Normal status : The contact area should be located in the middle of the tooth surface (near the pitch circle), with an area ≥ 70% and even distribution.
Abnormal performance : If the contact area is biased toward the tooth top or root, or distributed in a band/point pattern, it indicates axis coaxiality deviation or uneven tooth surface wear.
Operation method : Apply red powder on the tooth surface of the worm gear, turn the worm manually and observe the contact spots.
Tooth surface damage observation
Check whether the tooth surface of the worm gear (copper alloy) has scratches, glue (melted plaque) or pitting (pits), and whether the tooth surface of the worm (steel) is polished or dented.
2. Operation status monitoring
The noise and vibration
are uniform 'rustling' during normal operation. If there is a periodic 'clicking' sound or the vibration amplitude is >1.5mm/s (normal ≤0.8mm/s), it indicates abnormal meshing clearance or inaccurate tooth alignment.
Temperature Rise and Efficiency
If the oil temperature is >80°C or the transmission efficiency drops (for example, the output speed is lower than 90% of the rated value), it may be caused by increased friction on the tooth surface.
3. Precision measurement and adjustment
To detect the meshing clearance
, use a feeler gauge to measure the normal side clearance. The standard value is usually 0.1-0.3mm. If it exceeds the design value by 50% (such as >0.45mm), the center distance needs to be adjusted or parts replaced.
Axis coaxiality correction
uses a dial indicator to detect the axis deflection of the worm and worm gear. The radial runout should be ≤0.05mm, otherwise the bearing seat position needs to be adjusted.
4. Professional equipment assistance
The gear measurement center scans the tooth profile deviation, or uses CALYPSO software to analyze the single tooth wear curve to quantitatively evaluate the meshing accuracy.
