An important part of the reducer is a variety of reduction gears. A spur gear, helical, fan-shaped, worm gear is also a type of gear, and a planetary gear set. Under the interaction of these gears, the effect of deceleration is achieved to increase torque. Different deceleration application scenarios and application scopes are different. The wear of the gears caused is also different. If the gear wears too fast, it will be unavailable. All reasons and countermeasures should be found to avoid problems that will occur over and over again.
1. The common reasons for severe wear of reducer gears are mainly as follows:
Poor lubrication: poor oil quality, insufficient oil volume or timely oil supply, resulting in increased gear friction.
Overload operation: exceeds the load-bearing capacity of the reducer, causing the gear to bear excessive load.
Installation error: The gear is not installed correctly, such as the gap on the tooth side is too large or too small, the axis is not parallel, etc.
Impact load: impact caused by frequent start and stop, sudden loading or unloading, accelerate gear wear.
Material problem: The gear material is poor or the hardness is insufficient.
Overuse: As the use time increases, the gears naturally wear out.
2. To reduce the wear of the gears of the bad reducer, the following measures can be taken:
Ensure good lubrication: Choose the right lubricant, check and replenish the lubricant regularly to ensure that the gears are fully lubricated.
Reasonably design the transmission system: ensure that the reducer's load, speed and other parameters are within a reasonable range to avoid overload operation.
Improve assembly quality: correctly install and adjust the gears to ensure the meshing accuracy of the gears.
Regular maintenance: Clean impurities in a timely manner, check the gear condition, and deal with problems in a timely manner if they are found.
Use wear-resistant materials: choose gear materials with good wear-resistant properties.
