When the helical gear reducer is installed for the first time: why should we pay attention to the alignment of the central axis of the machine?It can not only prolong the service life of the helical gear reducer, but also ensure that the machine has good transmission efficiency, and the error of the central axis is not greater than the compensation amount of the coupling.When installing the shaft transmission part, use the assembly tool to install the transmission part in the correct way to ensure the integrity of the internal parts of the helical gear reducer.When choosing a fixed coupling, the manufacturer agrees not to use steel material.If the steel is not installed correctly, the machine will not work properly.
After the helical gear reducer is installed, it is necessary to effectively and comprehensively check whether the installation position of each transmission part of the machine is correct, so as to ensure the normal operation and rotation of the machine.Before operation, the oil level of the helical gear reducer should be filled until it flows out of the screw hole, and then a no-load test run for about 2 hours should be carried out.When the machine can run smoothly without vibration, impact, noise, or oil leakage, it means everything is normal, and the oil level of the machine needs to be checked regularly.
Whether the helical gear reducer runs smoothly or not depends on whether the base is firm, so as to ensure that the reducer does not generate vibration and noise during operation, and protect the shaft and gear from damage.If the helical gear reducer is driven by a gear or a sprocket, it is necessary to install a protective device for the machine to ensure that the output shaft can bear a large load and protect the safety of the machine.
