When first installing a helical gear reducer: why pay attention to the alignment of the machine's central axis?It can not only prolong the service life of the helical gear reducer, but also ensure that the machine has good transmission efficiency, and the central axis error is not greater than the compensation amount of the coupling.When installing a shaft drive, use assembly tools to install the drive in the correct manner to ensure the integrity of the internal parts of the helical gear reducer.When choosing a fixed coupling, the manufacturer agrees not to use steel.If the steel is not properly installed, the machine will not function properly.
After installing the helical gear reducer, the installation position of the machine transmission parts must be checked effectively and comprehensively to ensure the normal operation and rotation of the machine.Before operation, the helical gear should be filled with reduced oil level until it flows out from the screw hole, and then tested for about 2 hours without load.When the machine can run smoothly without vibration, impact, noise or oil leakage, everything is normal, and the oil level of the machine needs to be checked regularly.
The smooth operation of the helical gear reducer depends on whether the base is firm to ensure that the reducer does not generate vibration and noise during operation, and to protect the shaft and gear from damage.If the helical gear reducer is driven by gears or sprockets, protective equipment must be installed for the machine to ensure that the output shaft can bear a large load and protect the safety of the machine.
