Controller pin gear reducers are often referred to as planetary cycloid reducers because they employ the principles of cycloid pin tooth meshing and planetary transmission.As a driving or decelerating device in mining, metallurgy, construction, power generation and other industries. The application requirements are as follows. 1. The output shaft of the cycloidal wheel reducer cannot bear large axial force or radial force.If the axial or radial force is large, other methods should be used. 2. Allow the reducer to be used in a continuous operating system and operate in both forward and reverse directions. 3. The additional speed of the input shaft is 1500pm.If the input and output exceeds 18.5kW, a 960rpm 6-pole motor is recommended. 4. The working direction of the horizontal windmill reducer for horizontal equipment is horizontal.The horizontal inclination angle during installation is usually less than 15°.If it exceeds 15°, other methods should be used to ensure sufficient smoothness and avoid oil leakage.
