Hard tooth surface reducers are widely used in industrial and large-scale transmission-related equipment, and parts that have not been inspected, accepted by the technical and inspection department, unprinted and wet-painted are prohibited from being equipped.The assembly, partial assembly and final assembly of the hardened gear reducer must be carried out in accordance with the equipped process sequence without process intervention.
The parts of the hard tooth surface reducer should be cleaned before being equipped. The rolling bearings should be cleaned with gasoline or high-quality cleaning agent, and then dried with compressed air.When equipped, each mating surface shall not be corrected when equipped.Matching parts are required, except for repairing keys and keyways.Before the rolling bearing is installed on the shaft, the paint should be preheated and the thermal expansion should be calculated.
The hard tooth surface reducer should be debugged after being equipped, and the debugging speed should be close to the rated working speed of the reducer.It is strictly forbidden to add abrasives and impurities to the lubricating oil during debugging, and the contact ratio of the tooth surface should meet the requirements.After passing the hard tooth surface reducer, the skill assessment part will be printed and identified.Reducers that fail the inspection cannot be equipped with machinery and talent pools.The secret of the reducer machine packaged with molded parts is the identification and instructions of installation and post-processing.
The above is the installation standard of hard tooth surface reducer.I hope you can have a better understanding of its installation process after reading it.If anything is unclear, please feel free to contact us for consultation.
