The planetary gear reducer is a kind of transmission equipment with a wide range of uses. It is inevitable that it will make noise during operation. So what are the noise reduction measures for the planetary gear reducer?1. Properly increase the helix angle of the driving gear.As the helix angle increases, so does the gear overlap, which will greatly reduce noise.It should be noted that the appropriate helix angle needs to be selected.2. Increase the tooth surface width of the driven gear: If the tooth surface width increases, the meshing degree of the gears will also increase, the relative stability will also be enhanced, and the noise reduction effect will be better.3. Improve the gear precision: Improve the gear precision, which will greatly improve the gear surface roughness, thereby improving the gear movement precision and effectively reducing noise.4. Reasonable selection of tooth surface hardness and gear backlash: When the gear backlash is less than 0.04 mm, the noise is low, so the gear backlash can be appropriately reduced to reduce noise.In addition, when the hardness of the driving gear is 2-3HBC higher than that of the driven gear, the noise can be effectively reduced.5. For tooth surface Read More

When many people use the reducer, the output shaft of the reducer is often broken due to human factors such as illegal installation, which causes the company to suffer a lot of unnecessary losses.So, how to install the gear reducer correctly? The gear reducer manufacturer Huide Nuo will introduce in detail how to install the gear reducer correctly.In the reducer series, the gear reducer is used in gear, stepping, DC and other transmission systems because of its small size, wide deceleration range and high precision.Its function is mainly used to reduce the speed, increase the torque, and reduce the rotational inertia ratio of the load/motor under precision transmission.The correct installation and use of the reducer is an important part of ensuring the normal operation of mechanical equipment.Therefore, when installing the gear reducer, please be sure to carefully assemble and use it in strict accordance with the following installation and use related matters.1. Before installation, confirm whether the motor and reducer are in good condition, and strictly check whether the size of the connection between the motor and the reducer matches. Here is the positioning protrusion of the motor. Read More

1. Start the main motor and grind in the forward and reverse directions.During the grinding process, since the wear of the abrasive is quite fast, it is necessary to apply the abrasive to the gear from time to time to observe the change of the tooth surface.When the meshing contact area is t Read More

1. Start the main motor and grind in the forward and reverse directions. During the grinding process, because the abrasion of the abrasive is quite fast, it is necessary to coat the abrasive on the gear from time to time and observe the change of the tooth surface. When the meshing contact area of t Read More

What are the reasons for the motor burnout of the spiral reducer?The editor will introduce you one by one: 1.The compressor starts up frequently.During the starting process of the motor, although it is started by reducing vo, the starting current is still several times the rated current. Read More

What are the reasons for the burning of the motor of the helical reducer? A small editor will introduce you one by one:1. The compressor starts frequently. In the process of starting the motor, the starting current is still several times of the rated current although it is started by reducing the vo Read More