Lubrication and maintenance characteristics of B series industrial gearboxes
Publish Time: 2026-11-20 Origin: Site
1. Characteristics and solutions of lubrication system
The lubrication method of B series gearbox is not static, but is highly dependent on the installation form and model specifications:
1. Distinguish according to installation form
Horizontal installation: usually splash lubrication is used. The gear rotates in the oil pool and throws the lubricating oil to various lubrication points. The structure is simple and the maintenance cost is low.
Vertical installation: There are two options according to the size of the machine.
Oil immersion lubrication: suitable for models 6 and below. All parts that need to be lubricated need to be immersed in lubricating oil, and a compensation tank is usually attached to store the overflowing oil.
Forced lubrication: Applicable to models 7 and above. Forced splash lubrication of parts not immersed in oil is performed through a flange-connected oil pump or a separate electric oil pump.
2. Matching of heat capacity and cooling
In Selection and routine maintenance, the thermal capacity power must be calibrated. When the working conditions exceed the capacity of no auxiliary cooling or ordinary fan cooling, a cooling coil or additional cooling oil tank needs to be configured to prevent lubrication failure caused by excessive oil temperature.
2. Routine maintenance and troubleshooting
Good maintenance is the key to ensuring the long-term stable operation of the B series gearbox. It is recommended to focus on the following three dimensions:
1. Oil status monitoring
Check the lubricant level and quality regularly. Once the lubricating oil is found to be deteriorated or contaminated, it must be replaced in time to ensure the normal operation of the lubrication system.
2. Sealing and leak-proofing
Regularly check the gearbox for tightness. The B series is usually equipped with a unique sealing structure. Daily inspection of the joint surface and shaft extension is required to prevent oil leakage and avoid the intrusion of external impurities.
3. Operating status monitoring
Pay close attention to noise and vibration when the equipment is operating. The B series itself adopts a sound-absorbing box and large fan design to reduce temperature rise and noise. If abnormal vibration or abnormal noise suddenly occurs during operation, the machine should be stopped immediately for inspection to rule out gear wear or bearing failure.
3. Suggestions for shutdown and storage
For B series gearboxes that have not been used for a long time, they should be properly sealed and measures should be taken to prevent moisture, dust, and rust to avoid corrosion damage to the internal precision gears and bearings during idle periods.