The difference between hard tooth surface reducer and soft tooth surface reducer
Publish Time: 2021-09-14 Origin: Site
In the process of gear transmission design, especially closed transmission, if the hardness of the gear is not fully considered in the design, it will have a great impact on the performance of the transmission system.Such as common gear faults: tooth surface depressions, tooth root fatigue cracks, etc. are related to gear hardness and gear quality.According to the tooth surface meshing, the gears of the gear reducer are divided into soft tooth surface and hard tooth surface, which is reflected in the following applications:
1: Soft tooth surface gear transmission (tooth surface hardness ≤ 350HBs), at least one of a pair of gears is a soft tooth surface, which is usually used for general media and low-speed gear transmission, with low precision requirements.
2: Hard tooth surface gear transmission (tooth surface hardness > 350 HBS), both gears are hard tooth surface.It is usually used in gear transmissions with strong bearing capacity and small size.
In specific equipment, such as winches, soft tooth surfaces are commonly used, while hoists now mainly use hard tooth surfaces.
The following three points are usually considered in the design:
1: Closed soft-tooth surface gear transmission under normal working conditions.Soft tooth surface (≤350HBs) steel gear transmission: mainly based on tooth surface contact strength, design according to tooth surface contact fatigue strength; then check according to tooth root bending fatigue strength.
2: Suitable for gear drives with closed hard tooth surfaces.Hard tooth surface (> 350 HBS) steel gear and cast iron gear transmission: mainly based on the bending strength of the tooth root, and design the tooth root according to the bending fatigue strength; then check according to the contact fatigue strength of the tooth surface.
3: For open gear drives.The main failure mode is tooth surface wear and wear caused by tooth fracture.The design criteria are: design and calculate only based on the bending fatigue strength of the tooth root, determine the modulus, and increase the designed modulus by 10% - 20% to consider the influence of wear