Which is more efficient, cycloidal pinwheel reducer or worm gear reducer?
Publish Time: 2026-11-11 Origin: Site
1. Comparison of efficiency values under rated operating conditions
Cycloidal pinwheel reducer: Single-stage transmission efficiency is generally 90%~94%, and some high-precision models can reach 95%; double-stage reduction efficiency is about 88%.
Worm gear reducer: The efficiency of the non-self-locking arc tooth model is only 70%~90%, and the efficiency of the small-lead self-locking type is even lower, only 40%~60%.
The gap further widens at large speed ratios: the efficiency of a worm gear reducer with a 60:1 speed ratio may drop to 40% to 60%, while the cycloidal pinwheel with the same speed ratio can still maintain an efficiency of more than 90%.
2. Core reasons for efficiency differences
The cycloidal pinwheel adopts "pin tooth sleeve type rolling friction", with almost no relative sliding on the meshing surface and extremely low sliding loss.
The worm gear relies on the "full sliding contact" between the worm and the worm gear tooth surface to transmit power. A large amount of energy is converted into heat, and friction loss accounts for a very high proportion.
3. Efficiency performance under actual working conditions
Even if the cycloidal pinwheel operates continuously for a long time with heavy load, the efficiency attenuation is very small, and it is more energy-saving under the condition of 6000 hours of annual operation.
The efficiency of the worm gear is greatly affected by the transmission ratio and the type of lubricating oil. High reduction ratios cause serious heating, and long-term operation will accelerate the oxidation of the lubricating oil, further reducing efficiency.