What specific failures will occur in the reducer if the transmission shaft and motor shaft are not concentric?
Publish Time: 2026-11-04 Origin: Site
1. Damage to core transmission components
Gear mesh eccentric load failure: Concentricity deviation will concentrate the tooth surface load on the edge area, and the contact stress will suddenly rise to more than 2 times the design value. Reducers with soft tooth surfaces will experience tooth surface indentation and plastic deformation in a short period of time; reducers with hard tooth surfaces will develop fatigue pitting corrosion within 1-3 months, gradually developing into tooth surface peeling, and in severe cases, direct tooth collapse.
Sudden decrease in bearing life: When the radial deviation is 0.1mm, the additional radial force of the bearing can reach 30%-50% of the rated load, the contact point between the rolling element and the raceway is offset, and the local stress exceeds the standard. Calculated according to the bearing life formula, after the load increases by 50%, the remaining life of the bearing is only about 30% of the original design, and overheating, jamming or even rupture may occur in advance.
Shaft fatigue fracture: The input shaft continues to bear alternating bending loads, and the bending direction continues to change as the shaft rotates. The local temperature increases, the metal structure is destroyed, and eventually fatigue fracture occurs. Due to the larger output torque at the output end of the reducer, the risk of shaft breakage is higher than that of the motor shaft.
2. Rapid failure of connecting and sealing components
Premature damage to the coupling: The bolts of the rigid coupling bear huge shear force and break in a short period of time; the elastic elements (diaphragm, plum blossom pad) of the elastic coupling are repeatedly deformed, fatigue cracks or even breakage occur within 3-6 months, completely cutting off power transmission.
Shaft end seal failure and oil leakage: The eccentric rotation of the shaft will repeatedly squeeze the sealing lip, causing uneven lip wear, excessive sealing clearance, lubricating oil leakage from the shaft extension end, and at the same time, external impurities invade the box, further aggravating the wear of internal components.
3. Vibration and noise abnormalities
Periodic severe vibration: The eccentric rotation of the shaft system generates a centrifugal force proportional to the square of the rotational speed, causing high-frequency vibration of the entire machine, usually at 25-50Hz. The vibration transmitted to the base will cause the anchor bolts to loosen, further amplifying the concentricity deviation, and even triggering resonance, with the amplitude soaring from 0.1mm to more than 0.5mm.
Abnormal noise pollution: Gear impact meshing produces a metal "clicking sound" of 80-100dB, abnormal bearing friction produces a "grunting sound" of 75-95dB, and a sharp abnormal sound exceeding 100dB will appear after the coupling is broken. Long-term operation will damage the operator"s hearing, and will also cover up early faults and delay investigation.
4. Temperature rise and efficiency faults
Abnormal overheating of the entire machine: The gear sliding friction coefficient increased from 0.005 to 0.05-0.1, and the bearing friction torque increased by 50%-80%. The additional friction loss caused the temperature of the reducer to exceed 90°C. The lubricating oil rapidly oxidized and turned black, and the viscosity decreased, further deteriorating the lubrication conditions and forming a vicious cycle of "high temperature - lubrication failure - more serious wear".
Transmission efficiency drops significantly: Additional friction loss and vibration damping consume a large amount of ineffective power, and the transmission efficiency is 10%-20% lower than normal operating conditions. The motor operating current fluctuation increases and energy consumption rises significantly. Long-term operation will accelerate the aging of the motor insulation and even cause the motor to burn out.