Is there any way to reduce the parallelism error of the reducer?
Publish Time: 2026-11-18 Origin: Site
1. Pre-control in the manufacturing process
The box blank has undergone thermal aging + vibration aging to double stress relief to avoid hole position deviation caused by stress release in the later stage.
The bearing hole adopts the "one-time clamping and boring process" to eliminate the cumulative parallelism error caused by secondary flipping and clamping.
Before leaving the factory, the shape and position tolerances of the cabinets are checked one by one, and the JB/T9050.1 standard is strictly followed. Unqualified cabinets will not be included in the assembly process.
2. Precise calibration during assembly stage
The mounting base is finished to a surface roughness Ra3.2 or above, and the flatness error is controlled within 0.05mm/m.
Use the coloring method to check the contact spots of the gear pair. The contact area along the tooth length is ≥60% and the tooth height is ≥45%. Confirm that the parallelism of the shaft system is qualified.
If the contact is deflected, gradually correct the axis parallelism deviation by scraping the bearing bush or fine-tuning the position of the bearing seat.
The dial indicator dual-meter method is used to simultaneously measure the radial and end face runout to ensure that the axis parallelism error of the two axes is ≤0.04mm/1000mm.
Priority is given to the NL type elastic pin coupling, which can automatically compensate for the slight parallelism deviation generated after installation.
3. Precision locking after installation
Gradually tighten the anchor bolts 2 to 3 times in diagonal order. After tightening, the parallelism must be re-measured to avoid "false alignment".
The gaskets should be made of flat stainless steel sheets with a thickness of 0.05~0.5mm. The number of gaskets in a single set should not exceed 3. It is strictly prohibited to use paper, rubber blocks and other easily deformable materials.
After 30 minutes of no-load trial operation, the machine is deemed to be qualified if there is no periodic abnormal noise when monitoring the running sound, and if there is no obvious drift in the parallelism of the shaft system during retesting.
4. High-precision scene optimization
Using a laser aligner for calibration can improve the parallelism measurement accuracy to ±0.01mm, which is suitable for precision transmission conditions.
For chain/belt transmission structures, use a ruler close to the end face of the sprocket/pulley to ensure that the two end faces fit evenly and further control the parallelism deviation.