What is the reason for the broken shaft of the reducer?

Publish Time: 2021-10-29     Origin: WTG

There are a lot of parts in the reducer where the shaft is very important but sometimes the shaft breaks so I show that we see why this happens
Improper reducer selection
When purchasing a reducer, due to the wrong judgment of the torque, the torque of the output shaft is too large or too small, which can easily lead to the fracture of the reducer shaft.Some users think that as long as the rated output torque of the reducer is selected to meet their own needs, this is a wrong selection method.The value obtained by multiplying the rated output torque of the motor equipped with the reducer by the rated output torque of the reduction ratio is the rated output torque in principle, not the rated output torque of similar reducers provided in product samples.At the same time, the overload capacity of the motor and the maximum working torque required in practice should also be considered.Theoretically, the maximum working torque required by the user.It must be less than twice the rated output torque of the reducer.
Overload reducer
Overload operation is also the main killer of the fracture of the reducer shaft, which is the same as the praying mantis blocking the car.You can't overload without this great skill.Riational's use of reducers can not only reduce the occurrence of failures, but also prolong the service life of the reducer.
improper installation
Finally, it is very important to correctly install the reducer and the location of the equipment.Installing reducers in unstable places is a big no-no.It is easy to damage the reducer shaft during fluctuations.This can be well avoided by maintaining and maintaining the reducer during use.
If you use a reducer with acceptable quality, it will not damage the shaft.By reading the manual or consulting relevant staff before using the reducer, it can bring great convenience to the use process.
There are also reasons for the manufacturer, such as poor shaft quality, inconsistent shaft links, etc., so when purchasing a reducer, we must distinguish between good and bad manufacturers.Overall, older factories are more reliable.

FEEDBACK

How to detect early fracture of ZLYJ173 reducer gear

How to judge the degree of breakage of ZLYJ series reducer gears by listening to the sound

What are the common causes of failure of NGW102-6 planetary reducer bearing components?

What are the repair methods after the NGW81-25 planetary reducer bearing assembly fails?

How to judge whether there is a problem with the internal transmission pair of WP series reducer