What is the processing method of planetary reducer?

Publish Time: 2021-11-30     Origin: WGT

The weight of the planetary gear transmission is generally proportional to the weight of the gear, and the weight of the gear is closely related to its material and heat treatment hardness.For example, under the same power, the weight of carburized and quenched gears will be about 1/3 of that of quenched and quenched gears.Therefore, according to the structural characteristics of the planetary gear reducer and the load performance of the gears, hard gears should be widely used.There are many heat treatment methods to obtain hardened gears, such as surface quenching, overall quenching, carburizing and quenching, nitriding, etc., which should be selected according to the characteristics of the planetary gear reducer.
1. Surface quenching
There are two common surface hardening methods: induction hardening (for small size gears) and flame hardening (for large size gears).It works well when the case hardened layer of the hardened layer includes the bottom of the tooth root.Common materials for surface hardening have a carbon content of about 0.35%~0.5%, and the tooth surface hardness can reach 45~55Hrc.
2. Carburizing and quenching
Carburized and quenched gears have a relatively large load-bearing capacity, but a finishing process (gear grinding) must be used to eliminate heat treatment distortion to ensure accuracy.
Carburized and quenched gears are usually made of alloy steel, the carbon content before carburizing is 0.2%~0.3%, and the tooth surface hardness is usually in the range of 58~62Hrc.If it is lower than 57Hrc, the tooth surface strength is significantly reduced, and if it is higher than 62Hrc, brittleness increases.The hardness of the tooth center is usually 310~330hbw.The hardness of carburized and quenched gears should gradually decrease from the gear tooth surface to the deep layer, while the effective carburizing depth is specified as the depth from the surface to the deep layer, and the effective carburizing depth is specified as the depth from the surface to the deep layer with a hardness of 52.5HRC.
The effect of carburizing and quenching on the bending fatigue strength of gear teeth can not only increase the core hardness, but also the residual compressive stress located on the surface, which can reduce the stress in the large tensile stress region of the gear teeth.Therefore, the tooth root cannot be ground during tooth grinding, and the hob with the grinding allowance should be used during gear rolling.
3. Nitriding
Nitriding ensures high flank hardness with small deformations and improved bearing capability without the need for complete heat treatment.This has significant implications for internal gears where teeth are not easily ground.
4. Hardness combination of meshing gears
When both large and small gears have soft tooth surfaces, the tooth surface hardness of the small gear should be higher than that of the large gear.When both wheels have a hard tooth surface and high hardness, the hardness of the two wheels is the same.
The selection of a good planetary gear reducer material is conducive to improving the bearing capacity and service life of the gear reducer.

FEEDBACK

Pneumatic Conveying Gearbox Market 2027: Blower, Airlock and Screw Drive Demand

摆线针轮减速机两级速比怎么定:组合表怎么读、怎么校核、怎么落到机座号 - 杭州威高传动

Pellet Mill Gearbox Selection: Ring Die Torque, Thermal Rating and VFD Restart

Is there any way to reduce the parallelism error of the reducer?

Let me introduce in detail how to judge whether the worm gear joint surface of PWU160-40-V reducer is damaged.