What are the operating procedures for the servo planetary reducer?

Everyone is quite familiar with the servo planetary reducer. Many users do not know the operation process when using the reducer, which leads to failure. Today, the servo planetary reducer manufacturer will give you a brief introduction based on years of experience: the servo planetary reducer is installed. In principle, the model of the reducer bracket is determined according to the size of the output shaft diameter of the servo planetary reducer. As long as the interface form and size match, the size of the output shaft of the servo planetary reducer can be adjusted up and down within a certain range for the model of the servo planetary reducer bracket. branch.If the servo planetary reducer bracket with connection plate is selected, if the installation size of the servo planetary reducer does not match the reducer bracket, within a certain range, our company can adjust the connection between the speed connection plate and the servo planetary reducer to meet user requirements.

Bapman introduces the operating procedures of the servo planetary reducer:

1. Inspection before starting up

①. The reliability of fastening of each fastener;

②. Whether the oil level of lubricating oil meets the requirements;

③. Whether the wiring of the oil supply pump is correct;

④ Whether the coupling shield, grounding wire and other protective devices are properly installed.

2. Test run

①. After the installation of the servo planetary reducer is completed, a no-load test run should be carried out according to the working speed, and the time is about 2 hours;

②. After 2 hours of operation, the test run can be loaded step by step according to the load of 25%, 50%, and 75%, until it runs at full load;

③ After the load has been running for a period of time, check the contact of the tooth surface and whether the fasteners are loose.

3. Lubrication

①. The servo planetary reducer uniformly uses medium-duty industrial gear oil. The new oil to be replaced must be the same as the original oil brand, and different brands and different types of oil should not be mixed;

②. The height of the filling level should be 1/2 of the oil mark.

4. Precautions for maintenance, maintenance and operation:

①. All servo planetary reducers are strictly prohibited from starting under load.After replacing the accessories, it must be run-in and load test before it can be used normally.

②. During the use of the servo planetary reducer, close attention should be paid to the rotation flexibility of each transmission part, and the maintenance personnel should be notified in time of the abnormal sound and high temperature phenomenon found during the use.

③. Regularly check the tightening degree of the bolts and the amount of oil. When the oil level is lower than the lower scale line of the oil dipstick, the maintenance personnel should be notified in time to replenish the oil.

④. In order to make the servo planetary reducer easy to dissipate heat, the surface should be kept clean and the vent holes should not be blocked.

⑤. The operating servo planetary reducer should be inspected once an hour, and pay attention to observe the oil supply (servo planetary reducer) of the oil pump.Focus on inspections should be carried out on servo planetary reducers whose oil pipes are broken due to high oil temperature.