Oil hole and installation method of gear reducer

Publish Time: 2021-10-31     Origin: WGT

One of the reasons for purchasing the oil leaker of the gear reducer is to choose the wrong choice, resulting in a conflict between the installation method and the position of the oil hole, resulting in oil leakage from the oil hole.The correct mounting method should be provided during model selection, otherwise this result will occur.The following small series will explain this issue in detail.
When the reducer is working, the gears run at high speed and generate heat during the contact process through friction.If the machine does not provide an oil hole, the box is sealed.According to the principle of thermal expansion and cold contraction, the temperature increases and the pressure in the box increases.Not only the temperature cannot be dispersed, but also the oil seal will be affected, resulting in oil leakage of the reducer.
According to the above reasons, the oil hole needs to be opened before the reducer is used for ventilation and heat dissipation.The opening position of the oil hole changes with the position of the reducer.If the output shaft is mounted upwards, it should open close to the handle shaft.For example, if it is installed horizontally, the oil hole is on the top of the box.Therefore, ask about the correct installation method for model selection before purchasing.
If the gear reducer has been purchased, but the installation method has not been selected, it will not be replaced after the oil hole is opened.The gear is sealed and cannot be drilled out again as debris will enter the box and cause damage to the gear.If this installation method is wrong, if the machine does not work for a long time, the oil hole can lock the bolts that work about 8 hours a day.This method cannot be used if the working hours are too long.The lubricant in the tank is calculated as 8 hours per day.Under normal circumstances, it can be used for 5~8 years without replacement.

FEEDBACK

NMRV075-40 reducer oil level plug/oil drain plug oil leakage will not be repaired for a long time, will it affect the life of the reducer?

Oil leakage will cause damage to which internal components of the NMRV050-30-0.37KW worm gear reducer

Food and Beverage Gearbox Market 2027: Renovation Demand and Mixer Sizing

How to determine the export packaging of reducers: wooden box structure, fumigation mark and drop impact calibration example - Hangzhou Weigao Transmission

Marine Deck Winch Gearbox Selection: Drum Torque, Duty Class and Holding Brake