NMRV075-40 reducer oil level plug/oil drain plug oil leakage will not be repaired for a long time, will it affect the life of the reducer?

Publish Time: 2026-11-16     Origin: Site

From a troubleshooting and repair perspective, leaving things unchecked for a long period of time can cause the following chain reactions:

1. Core hazards: lubrication failure and irreversible wear

Oil film rupture and dry friction: The worm gear transmission itself has large sliding friction and high heat generation, and is extremely dependent on the lubricating oil film for lubrication and heat dissipation. Long-term oil leakage will cause the oil level to fall below the lower limit, causing "metal grinding metal" between gears and bearings.

Serious damage to the worm gear pair: In the absence of oil, the copper worm gear is prone to pitting, gluing, and even broken teeth, and the bearings will also be burned due to high temperatures. The wear of the worm gear pair is irreversible. Once damaged, it can only be replaced as a whole, and the maintenance cost is extremely high.

Lock-up in extreme situations: If the oil leaks and is not discovered in time, the reducer is forced to operate without lubrication, which will directly cause the internal gears to seize, the shell to burst, and the entire equipment to be completely scrapped.

2. On-site safety and operational risks

Leaked oil will not only pollute the production environment, but also easily cause people to slip and fall; if the oil comes into contact with high-temperature surfaces or motors, it may also cause fire hazards.

3. Maintenance and troubleshooting suggestions

For oil leakage at the screw plug, on-site treatment is actually not complicated. It is recommended to arrange shutdown for maintenance as soon as possible:

1. Check the seals and threads: Oil leakage from the screw plug is usually caused by the aging and deformation of the sealing ring (gasket), thread slippage, and improper assembly torque.

2. Standardize tightening and replacement: clean the oil dirt and iron filings on the surface of the screw plug and threaded hole, and replace with a new oil-resistant sealing ring. Be careful when tightening to avoid slipping due to excessive force.

3. Check the system pressure: Check whether the breathable cap on the top is blocked by dust and sludge. If the tank is under pressure, even if a new gasket is replaced, the oil will still be squeezed out by the high pressure.

4. Check the oil level: After the treatment is completed, be sure to replenish the lubricating oil to the center line of the oil window to avoid running without oil.

In short, although oil leakage from the screw plug is a minor problem, the price of delaying repair will be high gear repair costs or unplanned shutdown losses. It is recommended to intervene as soon as possible.

FEEDBACK

Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand

How to check the carrying capacity of worm gear reducer: working condition coefficient, efficiency and Selection calculation example - Hangzhou Weigao Transmission

Lubrication and maintenance characteristics of B series industrial gearboxes

What are the common misunderstandings in B series gearbox maintenance?

Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor