Installation and lubrication of cylindrical gear reducer
Publish Time: 2023-01-05 Origin: Site
1. Installation
1. Cylindrical gear reducers should generally be installed on a horizontal surface with an inclination not greater than 10°.If the slope is greater than 10° due to special needs, please contact our company to discuss related matters before use.
2. When the input shaft and output shaft are connected with the power and supporting machinery, if a coupling is used for connection, the shafts should be strictly centered without misalignment, and the V-belt and chain should not be too tight or loose.
3. The installation foundation should be firm and reliable, without vibration and looseness.Select fixing screws in strict accordance with relevant standards and regulations.4. From time to time, check whether the installation screws are tightened and fixed firmly.Gaskets use spring washers as much as possible.
2. Lubrication
1. The gear reducer is generally lubricated by an oil pool.Before use, be sure to add medium and extreme pressure gear oil N220 or N320 to the specified position (20-30mm above the lowest gear) and replenish it regularly.
2. After 50 hours of initial use, the engine oil should be replaced immediately to clean the oil stains inside the machine.Thereafter, it should be completely replaced every three months.
3. Please replace the oil seal as soon as possible.
f1 gearbox, use reducer, automatic transmission specialist near me, bevel gearbox, 90 degree gearbox,