How does the servo motor eliminate the gap of the gear reducer?

Planetary reducers are very common products in machinery and other fields.How does the servo motor eliminate the gap of the reducer?Now, let's take a look.

1. Seal the felt in the penetration cap.Soak it in heated liquid grease for 1-2 hours before installing.The sealing effect is quite good.

2. Replace the transparent bearing cover of the servo reducer.On the newly made bearing transparent cover, 2~3 annular grooves are mainly processed, and 6 oil return holes are evenly drilled.It should be noted that there is an oil return hole at the bottom (that is, the oil return hole is tangent to the annular groove), so that the oil return effect is good.

3. The air vent of the servo reducer is the place where dust and oil are most likely to combine.Usually, after a period of operation, the ventilator becomes clogged.Therefore, the key to solving the problem of 'running, leaking, and leaking' oil in the reducer is to enable the ventilator to breathe normally.To do this, change the ventilator (reducer attachment) to a single port.1. Seal the felt in the penetration cap.Soak it in heated liquid grease for 1~2h before installation.The sealing effect is quite good.