Dynamic and Static Analysis of Cycloidal Reducer

Publish Time: 2021-11-19     Origin: WGT

In the dynamic and static analysis of the existing cycloidal moderator, according to the structural size and mass distribution of each component, the mass inertia and center of mass position of each component are obtained by calculation or experimental methods, and then the operation part is pressed.Considering the law of motion, the movement of the actuator is analyzed, and the acceleration and angular acceleration of the center of mass of each component are obtained.
The inertial forces and moments of inertia of the cycloidal moderator components are then determined.Using these forces, a dynamic and static analysis of the mechanism can be started and the reaction forces (or equilibrium torques) acting on each pair of motions of the mechanism can be obtained.
If the design of a new mechanism is performed, parameters such as the mass size and the moment of inertia of the inertia are usually uncertain before the dynamic and static analysis of the mechanism.In this case, design is often based on design.Given the conditions, experience and structural dimensions of each component, determine their mass and moment of inertia, and perform dynamic and static analysis.

FEEDBACK

What is the clearance standard of P series planetary reducer under different working conditions?

How to choose the P series planetary reducer suitable for your equipment

How to detect early fracture of ZLYJ173 reducer gear

How to judge the degree of breakage of ZLYJ series reducer gears by listening to the sound

What are the common causes of failure of NGW102-6 planetary reducer bearing components?