Cycloidal gear reducer conditions

Publish Time: 2021-08-28     Origin: 中国威格装备箱

1. Allows cycloidal gear reducers to be used in continuous work systems, allowing both forward and reverse directions.

2. The rated speed of the input shaft is 1500rpm.When the input power is greater than 18.5 kW, it is recommended to use a 6-pole motor with 960 rpm.

3. The working position of the horizontally installed cycloid reducer is horizontal.The maximum horizontal tilt angle during installation is usually less than 15°.Additional measures should be taken to ensure adequate lubrication and to prevent oil leakage when 15° is exceeded.

4. The output shaft of the non-cycloid reducer cannot be subjected to large axial and radial forces.Additional measures must be taken when large axial and radial forces are present.

FEEDBACK

How to determine the gear shaft of the reducer: root circle constraints, shaft fatigue check and separate Selection boundary - Hangzhou Weigao Transmission

Wastewater Treatment Gearbox Market 2027: Policy Deadlines and Screw Pump Sizing

How to calculate the fatigue life of reducer gears: GB/T 3480.6 Variable load Miner damage accumulation calculation example - Hangzhou Weigao Transmission

Vertical Turbine Pump Gear Drive Selection: Thrust Load, Support and Bearing Life

How to determine the shaft diameter and key of the reducer output shaft: shaft diameter estimation, bending and torsion combined strength and flat key connection calculation examples - Hangzhou Weigao Transmission