Are the maintenance methods of different types of helical gear reducers the same?

At the beginning of the installation of the helical gear reducer: why should we pay attention to the alignment of the central axis of the machine, which can not only prolong the service life of the helical gear reducer, but also ensure that the machine has good transmission efficiency, and the error of the central axis is not greater than the compensation of the coupling quantity.When installing the shaft transmission part, use the assembly tool to install the transmission part in the correct way to ensure the integrity of the internal parts of the helical gear reducer.When choosing a fixed coupling, the manufacturer agrees not to use steel material.If the steel is not installed properly, the machine will not work properly.
After the helical gear reducer is installed, it is also necessary to effectively and comprehensively check whether the installation position of each transmission part of the machine is correct, so as to ensure the normal operation and rotation of the machine.Before operation, the oil level of the helical gear reducer should be filled until it flows out of the plug screw hole, and then it should be run for about 2 hours without load.When the machine can run smoothly without vibration, impact, noise and oil leakage, it means that everything is normal, and the oil level of the machine needs to be checked regularly.
The stable and unstable operation of the helical gear reducer depends on whether the base is firm, so as to ensure that the reducer does not generate vibration and noise during operation, and protect the shaft and gear from damage.If the transmission of the helical gear reducer uses gears or sprockets as the transmission device, it is necessary to install a protective device for the machine to ensure that the output shaft can withstand a large load and protect the safety of the machine.