Advantages of helical gear reducers compared with spur gears

Publish Time: 2021-09-16     Origin: 威高传动

The disadvantage of spur gear reducers compared to helical gear reducers is that they generate vibration.Whether due to design, manufacturing, or deformation, some variation in the involute shape may occur along the entire tooth flank at the same time.This will result in one contact per tooth, which is usually very strong.The resulting vibrations not only place high loads on the gears, but also generate noise.
Another disadvantage of spur gear reducers is that when in contact, the additional strength gained by meshing two pairs of teeth is sometimes not available, because the stresses generated by meshing single teeth in the cycle are limited.
Then the helical gear reducer is different.Its helical gear can be regarded as a cylindrical gear formed by a set of thin plate gears misaligned.In this way, the contact of each plate is at different parts of the tooth profile, thereby playing the role of compensating the error of each thin plate gear.This compensation function is very effective for the elasticity of the teeth and is also good for the load-bearing strength.
Furthermore, manufacturing and assembling a large number of thin spur gears is complex, difficult and uneconomical.Therefore, manufacturers make connecting gears that have teeth along the helical direction.Although helical gears are not like spur gears, they produce poor axial forces.But the advantages of reducing vibration and improving bearing strength far outweigh the disadvantages of slightly increased axial thrust and manufacturing cost.Therefore, in the manufacture of gear reducers, helical gears are often used instead of spur gears.

FEEDBACK

How to detect early fracture of ZLYJ173 reducer gear

How to judge the degree of breakage of ZLYJ series reducer gears by listening to the sound

What are the common causes of failure of NGW102-6 planetary reducer bearing components?

What are the repair methods after the NGW81-25 planetary reducer bearing assembly fails?

How to judge whether there is a problem with the internal transmission pair of WP series reducer