Article List

• Characteristics of cycloidal pinwheel reducer

  0 high speed ratio and high efficiency single-stage transmission can achieve a reduction ratio of 1:87, with an efficiency of more than 90%. If multi-stage transmission is adopted, the reduction ratio will be greater.The reduction ratio of primary transmission is 9 ~ 87, the reduction ratio of dual

  May 26, 2022
• Analysis of oil leaks leading to reducers

  1. The pressure in the tank increases.In a closed reducer, each pair of gears generates heat as they mesh and rub together.According to Boyle Mallott

  May 26, 2022
• Cause analysis of oil leakage in reducer

  1. The pressure in the oil tank rises. In the closed reducer, each pair of gears will generate heat when they mesh and friction. According to Boyle mallott's law, with the extension of operation time, the temperature in the reduction box will gradually rise, while the volume in the reduction box wil

  May 26, 2022
• R series reducer, how do you store it?

  After receiving the R series reducer, the long-term storage period is 6 months, but the packaging must be guaranteed to be completed.The storage location must not be open, the temperature must not be lower than + 5°C, not higher than + 40°C, and the relative humidity must not be greater than 80%.

  May 26, 2022
• R series reducer, how do you store it?

  After receiving the R series reducer, the long storage period is 6 months, but it must be guaranteed that the packaging is complete. The storage place shall not be open, the temperature shall not be lower than + 5 ℃, not higher than + 40 ℃, and the relative humidity shall not be greater than 80%.The

  May 26, 2022
• Advantages of helical gears over spur gears for educators

  The disadvantage of stimulator lowering gears compared to helical gear reducers is that they generate vibration.Whether due to design, manufacturing, or deformation, some changes may occur simultaneously along the entire tooth surface at the same time.This will result in one contact per tooth, which is usually

  May 16, 2022
• Advantages of helical gear reducer over spur gear educer

  The disadvantage of spur gear reducers compared to helical gear reducers is that they produce vibration. Whether due to design, manufacture or deformation, some involute shape changes may occur simultaneously along the whole tooth surface. This will result in each tooth touching once, which is usual

  May 16, 2022
• Note in gear reducer wear repair

  Gear reducer is the key equipment of vertical mill system. As the task and working conditions of gear reducer are particularly harsh, it needs to run continuously under the conditions of shock, vibration and overload, and its service life is required to be more than 15 years, which requires high rel

  May 16, 2022
• Watch out for gear wear and repairs

  The gear reducer is the key equipment of the vertical mill system.Since the task and working conditions of the shifter are particularly severe, it needs to operate continuously under the conditions of shock, vibration and overload, and its service life must exceed 15 years, which requires a high degree of correlation

  May 16, 2022
• Are different types of helical gear reducers maintained in the same way?

  When the helical gear reducer is first installed: why should attention be paid to the alignment of the center shaft of the machine? It can not only prolong the service life of the helical gear reducer, but also ensure that the machine has a good transmission efficiency, and the center shaft error is

  May 16, 2022