Worm gear wear fault of worm gear reducer and its solution
Publish Time: 2021-11-30 Origin: WGT
Worm gears wear out.Worm gears are usually made of tin bronze.The matching worm material is usually hardened to HRC45-55 with 45 steel, and 40°C: Hardened to HRC50-55 is also commonly used.It is the roughness Rao.8fcm of the worm grinder.During normal operation of the reducer, the worms act like hardened 'files' and keep sifting through the worm gear causing wear on the worm gear.Generally, this wear is slow.Just like some factory reducers, they can be used for more than 10 years.If the wear rate is fast, you need to consider whether the choice of reducing agent is correct, whether there is overload operation, worm gear material, assembly quality or service environment.Solutions: Select lubricants and additives.Worm gear reducers usually use 220# gear oil.For some reducers with heavy loads, frequent starts and poor environments, the factory also selects some lubricating oil additives (such as Anzhi Chemical Company).When the reducer stops running, the gear oil still adheres to the gear surface to form a protective film to prevent heavy load and low speed, metal to metal contact during high torque and start-up.The additive also contains seal ring regulator and anti-leakage agent to keep the seal ring soft and elastic, effectively reducing lubricating oil leakage.