Why is the planetary reducer broken?

Why is the shaft of the planetary reducer broken.The first problem that may arise in the case of a large broken shaft is the quality of the planetary reducer.Of course, this is what we can usually think of, mainly because of the usual use process.For example, what should be paid attention to during the acceleration and deceleration process of using the planetary reducer, and what are the good methods.The following are the three major reasons for Shanghai Jinchuan reducer.
1. Some applications must strictly abide by this criterion, which is not only for the protection of the reducer, but also to prevent the output shaft of the planetary reducer from being broken.This is mainly because if there is a problem with the installation of the equipment, the output shaft of the reducer and its load will be stuck.At this time, the overload capability of the driving motor will still increase its output.In turn, the force on the reducer output shaft may exceed twice its rated output torque and twist the reducer output shaft.
2. During the acceleration and deceleration process, if the instantaneous torque of the output shaft of the planetary reducer is multiplied by more than twice its rated output torque, and this acceleration and deceleration is too frequent, it will eventually cause the reducer to break the shaft.Considering that this kind of situation occurs relatively rarely, it will not be repeated here.
3. The error of Selection leads to insufficient output of the equipped reducer.Some users mistakenly think that as long as the rated output torque of the selected planetary reducer meets the work requirements, it is not the case.1. The value obtained by multiplying the rated output torque of the equipped motor by the reduction ratio is in principle smaller than the rated output torque of the same type of reducer provided by the product sample; 2. The overload capacity of the driving motor and the actual large working torque.In theory, users need a large working torque.Must be less than twice the rated output torque of the reducer.
When using a planetary reducer, you must pay attention to its code of conduct. If you choose the wrong one, there will be fatal reasons for insufficient output.If the output of the reducer is too small, the problem of broken shaft will occur.The broken shaft of the planetary reducer is a common problem.In addition to the poor assembly concentricity of the output end of the reducer, the reducer shaft is broken.The above three points are possible causes and problems.