Whether the oil return of the cycloidal reducer is smooth? An important factor for the oil leakage of the cycloidal reducer
Publish Time: 2023-07-13 Origin: Site
After using the cycloid reducer for a long time, we need to check and find some dangers in time.In order to keep the equipment running, we usually add oil immediately, but we should also solve the oil leakage problem immediately.So, let's take a look at how to solve the oil leakage problem of the cycloid reducer.
1. Seriously implement the maintenance process.During the inspection, the process regulations must be carefully implemented.Do not install the oil seal in reverse to deform the outer edge and cause the spring to fall off. Clean the joint surface and apply the sealant evenly, or keep the oil volume below the oil level.
2. Ventilate the hole cover, check the hole cover Therefore, an oil cup type exhaust cover is made, if the pressure inside and outside the machine is balanced, it can prevent oil leakage.Open the inspection hole cover every time you refuel.Once opened, the possibility of oil leakage increases once and the pressure equalizes.When refueling, there is no need to open the hole cover of the reducer for inspection.Refueling through the oil cup, the internal pressure of the reducer is greater than the external atmospheric pressure, which is one of the main reasons for oil leakage, thereby reducing the chance of oil leakage.The leak will occur at the original location.
3. Wipe.The leakage of the dynamic sealing point is still very small.Due to age, poor quality, improper assembly and high shaft surface roughness, static seal points can often be treated to prevent leakage.Therefore, after the device stops running, it is necessary to wipe the oil on the shaft.
4. Keep unobstructed.The oil return groove inclined to the inside of the machine is located at the opening of the lower casing of the casing.In order to prevent the reducer gear from accumulating too much lubricating oil at the shaft seal, there is a gap at the straight mouth of the end cover, so the excess lubricating oil needs to flow into the oil return pool in a certain direction.
5. Using new sealing materials, new polymer materials can be used for static sealing points of fixation, oil leakage and leakage,
6. The shaft seal structure does not need to be filled with oil.Be aware of the possibility of oil leaks, especially when checking the tank.
The above is how to solve the oil leakage problem of the cycloid reducer.Other data is the part of the design process that requires careful planning.We can imagine the importance of gears to cycloid reducers.Therefore, when designing gears, we should abide by the above principles in order to improve the efficiency of the equipment.If you need to know more, please feel free to contact us!